Generic Polycom Provisioning for Vintalk Hosted
Posted by Bob Russo on 02 September 2015 02:04 PM

This is a quick step through for provisioning most Polycom phones when used on the Vintalk Hosted platform. This is not valid for use with the ESI Hosted PBX.


                                       Polycom Provisioning


  1. Factory reset the phone.
    1. Press Menu>Settings>Admin Settings>Reset to Defaults>Reset Local Config

                a. Format File System

  1. Re-provision the phone.
    1. Press Menu
    2. Press the number 3
    3. Press the number 2
    4. Enter password 456
    5. Press the number 1
    6. Press the number 1
    7. Scroll down and select the three dots below Server Menu
    8. Server Type needs to be HTTP
    9. Server address:
    10. Remove any username and password information as it’s not needed.
    11. Save settings and reboot.



courtesy Robert Kviz

(0 votes)
This article was helpful
This article was not helpful

Comments (0)
Help Desk Software by Kayako