Knowledgebase
Provisioning the Linksys PAP2T
Posted by on 09 July 2012 03:18 PM
In order to provision the Linksys PAP2T, follow the below steps to factory reset it and point it to our provisioning server.
  1. Plug in the power, ethernet cable (into the WAN port), and an analog phone into the ATA.
  2. Press the * key four times, then 73738, then 1, then #. Hang up.
  3. Press the * key four times, then 7932, then 1, then #.  Hang up.
  4. Press the * key four times, then 110, then #.  This will give you an internal IP address, you will need to write this down.
  5. Enter the IP address in a browser. It will take you to the device's web interface.
  6. Go into Admin Login > Advanced Settings. Click on the provisioning tab above.
  7. Put the following in the profile rule: http://ndp.vincomm.net/cfg/$MA.cfg
  8. Once you’ve pasted the address and saved the settings, power cycle the ATA.
(0 votes)
This article was helpful
This article was not helpful

Comments (0)
Help Desk Software by Kayako support.esi-estech.com/index.php?