Attached is a Pre-Programming Check List that should be utilized
before programming an IP-900
When creating a Kayako ticket to report issues with calls such as
calls dropping or having poor audio (static, garbled, etc.) Please
click on the Quick insert for Macro and use the pull down for "Call
Examples". This will provide a guide as to what inf...
REASONS FOR RESETTING A REPEATER
You may need to reset an ESI Cordless Handset II Repeater if you:
* Want to register the Repeater to a different base station or
Repeater.
* Are having trouble registering the Repeater to a base station or
R...
The purpose of the attached document is to lay out the steps taken to
integrate a Session Initiation Protocol (SIP) phone - also called a
VoIP, or Voice over Internet Protocol, phone - that is not Estech
Systems, Inc (ESI) equipment (Cisco, Polycom, et...
The purpose of this configuration guide is to describe the steps
needed to configure the ESI IP Server 900 PBX for proper operation
with ESI SIP Trunks. Please note that this guide documents the basic
configuration needed in the ESI-900 PBX and the requir...
When a module is removed from the IP Server 900, the system will
retain all programming information and configurations for the module.
This is done to insure programming isn't lost because of a module
needing to be replaced. This however can cause conf...